1 Reply Latest reply on Jun 3, 2010 7:31 AM by Greg Kullberg

    Re-Provisioning Blades

      Whenever I execute a UCS Provision Job it creates a new Service Profile and then starts provisioning based on the System Package that I associated with it.  However, if there is ever a failure at any point in the process, it seems I need to start again from scratch, which involves creating a new UCS Provision Job, deleting the old one, and deleting the Service Profile that was created.  Is there a better way to do this?

        • 1. Re: Re-Provisioning Blades

          If you want to leverage the same Service Profile that the initial UCS Provision Job created, then you don't need to create a new UCS Provision Job each time.  If the Service Profile was created successfully, you should see the MAC address for that device show up under Devices -> Imported.  You can re-provision this device directly by creating a Provision Job, which is much faster than having to refresh the Service Profile.