1 Reply Latest reply on Jun 12, 2008 8:49 AM by Bill Robinson

    blcli createSnapshotToSnapshotAuditJob

      blcli AuditJob createSnapshotToSnapshotAuditJob


      I've created an audit job using the above command, specifying to run a snapshot against two entire snapshots, but the job created doesn't work. Says no targets for audit. Looking at the job it appears that the command above is still being created as if it is using a component template to audit against, it does have a template in the target window, but it's not one i've created so I don't know where its getting it from.

      I know the command can be used in two ways according to the blcli help, but it seems to ignore what parameters you're passing in.


      BladeLogic v7.3


      Any help would be great...