3 Replies Latest reply on May 18, 2009 2:55 PM by Bill Robinson

    Running a Compliance Job on the output of a command

    Dan Chan

      Hello,

       

       

      I'm trying to run a compliance job to verify if a specific WAS patch as been applied. The command outputs a lengthy result, and only a portion of the result is needed to compare against?

       

      What is the best way to do this?

       

       

      I have tried 'grep'ing the result to an extended object (which does output the data without error), however, when I put it in to a component I recieve the following error:

       

      com.bladelogic.model.AssetInvalidAssetTypeException:

      com.bladelogic.mfw.util.NotFoundException: ExtConfigDef not found.

       

      So as a result, my compliance job fails. Though there may be a better way to do this, thus my first question.

       

       

       

      Many Thanks!