3 Replies Latest reply on May 18, 2009 2:55 PM by Bill Robinson

    Running a Compliance Job on the output of a command





      I'm trying to run a compliance job to verify if a specific WAS patch as been applied. The command outputs a lengthy result, and only a portion of the result is needed to compare against?


      What is the best way to do this?



      I have tried 'grep'ing the result to an extended object (which does output the data without error), however, when I put it in to a component I recieve the following error:



      com.bladelogic.mfw.util.NotFoundException: ExtConfigDef not found.


      So as a result, my compliance job fails. Though there may be a better way to do this, thus my first question.




      Many Thanks!