OS Deployment - The image you have captured is only a couple of MBs

Version 4
    Share This:

    If the image you have captured is only a couple of MBs it's probably because you have captured Windows 7's hidden partition.

    This can happen when you are running a version of FPAC that didn't offer the ability to select the "System" disk, and that you have to specify a disk to capture:

    osd_sys.png

     

    To make sure of the disk you have to capture you can:

    - Go to the project properties and select "None" instead of "Shutdown" or "Reboot"

    osd_None.png

    Then recompile and restart the device or rerun the runsysprep.bat.

     

    - When the project will have failed you'll be able to use the MS-DOS window (if not you might want to try "Ctrl + Tab" or "Shift + F10 i think, to launch a new one)

     

    - Type "notepad" in the MS-DOS window then "Open" to browse the disks

     

     

    Note:

    - This document applies to FPAC =< 11.7 and probably followings.

     

    Please consider marking this post as correct or recommandable if you found it usefull.