How can I see if an IMS region is looping?

Version 1
    Share:|

    This document contains official content from the BMC Software Knowledge Base. It is automatically updated when the knowledge article is modified.


    PRODUCT:

    MainView for IMS Online



    QUESTION:

    How can I see if an IMS region is looping?
     


    ANSWER:

    To monitor if an IMS region may be in a loop you can access the Region Loop Check view ( IRGOLOPR), here you can view if any of your active IMS regions are in a loop as well as see other useful statistics. Additionally, when you have defined alarms using the Solution Profiles, the data collected by this view is used to trigger the alerts. 

    To access this view enter IRGOLOPR on the MainView command line, from here you will be taken to the Region Loop Check View.  



    Command line

    view


    Article Number:

    000166307


    Article Type:

    FAQ/Procedural



      Looking for additional information?    Search BMC Support  or  Browse Knowledge Articles